Sorry if this is in the documentation- if my Russian was half as good as your English, I might have found it!
I'd like to know if the SECU-3 ECUs support Nissan optical triggering? Specifically the SR20DET 360 + 4 CAS trigger.
Also, am I correct in assuming the SECU-3T will support sequential fuel and ignition on a 4 cylinder?
Would love to get a pin on the map here in Australia!
cheers
Ash
SECU-3 trigger support
- STC
- Posts: 13843
- Joined: 30 Apr 2013, 23:41
- Your CAR: AZLK 2140
- SECU version: DIY SECU-3
- Location: North Korea
- Has thanked: 2160 times
- Been thanked: 4335 times
- Contact:
Re: SECU-3 trigger support
Hi,
No, current firmware doesn't support 360 + 4.I'd like to know if the SECU-3 ECUs support Nissan optical triggering? Specifically the SR20DET 360 + 4 CAS trigger.
SECU-3 Firmware support full sequential ignition and injection. For this, you should use SECU-3 Manager and firmware of version 4.7. Can be found here http://secu-3.org/forum/viewtopic.php?f ... =10#p42495Also, am I correct in assuming the SECU-3T will support sequential fuel and ignition on a 4 cylinder?
Author of the SECU-3™ project http://SECU-3.org. An open source engine control unit / Ignition control system, (C) 2007.
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)