Hi. I'm in the process (finally) in configuring the SECU-3 Micro to drive my 1968 Morris 1310cc 4cyl Mini ignition. I will be using:
1. A Hall effect TPS -> CARB
2. A GM temp sensor -> TEMP
3. 1 wasted spark coil (VAG logic level, so will be driven directly from SECU-3 Micro -> IGN_OUT1 & IGN_OUT2
4. 1 VR CKP sensor using a 36-1 sensor wheel -> CKPS1 & CKPS2
5. GM 1Bar MAP Sensor -> MAP_S
My question is, can the GAS_V be configured as an O/P? I want to use it as an O/P to drive a solid state relay for my electric radiator fan.
Jim
SECU-3 Micro Configure GAS_V as O/P
-
- Posts: 3
- Joined: 02 Nov 2016, 03:42
- Your CAR: 1968 Morris Mini
- SECU version: official SECU-3 Micro
- Location: Melbourne, Australia
- Been thanked: 1 time
- Contact:
- STC
- Posts: 13843
- Joined: 30 Apr 2013, 23:41
- Your CAR: AZLK 2140
- SECU version: DIY SECU-3
- Location: North Korea
- Has thanked: 2160 times
- Been thanked: 4335 times
- Contact:
Re: SECU-3 Micro Configure GAS_V as O/P
Hi,
GAS_V is input, not output. Because, two existing outputs are already busy, the only way to control a relay is to add several components (transistor, two resistors and diode) and connect them to the one of MCU ports.
GAS_V is input, not output. Because, two existing outputs are already busy, the only way to control a relay is to add several components (transistor, two resistors and diode) and connect them to the one of MCU ports.
Author of the SECU-3™ project http://SECU-3.org. An open source engine control unit / Ignition control system, (C) 2007.
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)
- STC
- Posts: 13843
- Joined: 30 Apr 2013, 23:41
- Your CAR: AZLK 2140
- SECU version: DIY SECU-3
- Location: North Korea
- Has thanked: 2160 times
- Been thanked: 4335 times
- Contact:
Re: SECU-3 Micro Configure GAS_V as O/P
For using electromechanical relay or solid-state relay:
Author of the SECU-3™ project http://SECU-3.org. An open source engine control unit / Ignition control system, (C) 2007.
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)
Клуб проекта в Facebook https://www.facebook.com/groups/secu3club
Клуб проекта ВКонтакте https://vk.com/secu3club (вступаем!)