Advance curve maps
Posted: 26 Nov 2016, 12:43
Question on the WorkAngle Map, there are 16 sets which are for the changing air flows, is 1 the lowest or the highest air flow. The example curve has the greatest advance at air flow 1 and lowest at flow 16, note that I am setting the curve for a carb slide which is directly linked to the throttle and not a CV carb so at low revs if you open the throttle to WOT the air speed will drop, the mixture weakens and you risk pinking.
Also I can only seem to be able to edit one named table called tunable set, how do I get to edit all the named tables, if I go into 4 Functions and select different named tables for gasoline and gas when I then select edit tables it still only gives me the same table regardless and the Table set name reverts to the first one I renamed from tunable set. Got that sorted mostly, by going to Firmware data and reading Flash from Secu-3 I could then edit the tables for the 4 named tables and the names for the tables.
Also I can only seem to be able to edit one named table called tunable set, how do I get to edit all the named tables, if I go into 4 Functions and select different named tables for gasoline and gas when I then select edit tables it still only gives me the same table regardless and the Table set name reverts to the first one I renamed from tunable set. Got that sorted mostly, by going to Firmware data and reading Flash from Secu-3 I could then edit the tables for the 4 named tables and the names for the tables.